![]() ![]() This is usually done by holding the power button and volume down button (Vol down is the one closest to the power button) simultaneously and releasing the power button when the white Samsung Galaxy Tab 2 10.1 logo comes up. Battery was charged to 100% the entire time.Ģ) I could not enter the ASR (Android System Recovery) mode to try the other suggested options of clearing the cache or wiping the tablet back to factory settings. The tablet can not be forced off (holding power button down) unless the charger is connected. It will continue this cycle continuously. Solved for a Samsung Galaxy Tab 2 10.1 (GT-P5110) stuck in boot loop AND unable to enter ASR recovery mode.ġ) Boots to white Samsung Tab 2 screen, and then through to coloured animated Samsung logo where it then gets stuck and commences booting again. You should attempt firmware flash first if you need to keep user data that's on the device then do factory reset as that is the only option after that. It can also be caused by corrupt firmware too. Stuck on animated Logo usually means the partition on the device that is used for user data is corrupt and needs to be wiped by doing the factory reset method.Stuck on white Samsung Logo usually means device is soft-bricked (Recoverable using firmware flash), caused by a bad battery or insufficiently charged battery.If this still doesn't solve the problem then you will need to restore firmware using Samsung Kies (ODIN downloader flash method works too). Wait for this to complete and reboot tablet. Use volume keys to navigate the menu and the power / home key to select the highlighted option.ĭo wipe data / factory reset. Once you get into a recovery menu which usually release all keys. When Samsung logo appears stop holding the power button but continue holding the other buttons. Hold power button + volume up + home button until Samsung logo appears. If firmware flash does not help then a factory reset must be done to get the device working again.ĭisclaimer: I am not responsible for any data lost from your device when you follow the steps below: If you need to keep the user data (photos and etc) try flashing latest android system firmware first by following instructions provided in link below: Usually when the Tablet is stuck on the animated Samsung Logo you may need to do either a factory reset or reflashing firmware on tablet (same android version or newer). ![]() Try leaving it on charge for half an hour if that does not work you may need to do a factory reset or reload the software on the tablet in order to get it working again. Try holding power + volume down for 10-15 seconds and attempt to turn it on and or charge it again. I have admin access on my Windows 7 laptop.Before reading below there is a common issue with these tablets where they do not turn on properly or get stuck on the charging battery icon. How can access this Samsung mobile from my laptop? Even this application is not able to access the mobile.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |